Question about remotes

[bus1962]

Will a 8.0 UHF remote work with a 6131 receiver or is there a way to change the UHF to IR. Maybe switch the bottom piece over but I tried to take it out and it's not coming out any ideas or I just wasted money

[Terryl]

Try this;

Press and hold SAT until all 4 lights flash.
Press 2.
Press #.
SAT should flash 3 times to verify a valid code.

If this doesnt work then you need to check the menus to see what the remote address should be.

[bus1962]

I did that the remote number is 4 and I did exactly what you mentioned and pressed 4 instead of 2 and it flashes 4 times I save it and it doesn't operate the ird so I'm out of option