Boot Message To Receiver Only What's happen...

[peterpeete]

Hello, I don't understand, I listen the channel and I lost the signal satellite.

I check the cable, connexion, voltage to power supply, and it's correct 12 volts,

but when I open the power swtich, it's write boot to the receiver and nothing happen...before I can see the clock or the channel...

Does somebody can tell me what's happen...

Thank you...

[peterpeete]

Nothing...

[The Noof]

Remove the top cover & check the voltage on the circuit board at the power header when the unit fails to boot.Just because the PS has enough poop to power a volt meter, it doesn't mean it supplies enough in-circuit current.Power supplies should be checked in-circuit.

[peterpeete]

You are reason, I changing the power supply to a 12 V. 3 A and it's correct but for how much time...

Thank you...

[KIDWCKED]

Hello, I don't understand, I listen the channel and I lost the signal satellite.

I check the cable, connexion, voltage to power supply, and it's correct 12 volts,

but when I open the power swtich, it's write boot to the receiver and nothing happen...before I can see the clock or the channel...

Does somebody can tell me what's happen...

Thank you...

how can you tell if you lost satellite signal when your rcvr won't boot?
i would do some reading here..
DREAMLINK HD T5 (https://www.satfix.to/forumdisplay.php?1520-DREAMLINK-HD-T5)

[marcel.crash]

first turn power switch off then try disconnecting the satellite cable from the receiver then power it back up with out the sat cable , just to see if the receiver ore the cable

[The Noof]

I think he said it was the power supply,&it'sworking now.