My T5 won't scan 82 even after replacing it with new dl200

[jas123]

Hey guys, I recently wasn't able to scan any 82 on my T5 though it was my module card.. I bought a new module card this morning, replaced it with the old one and I'm still out of luck it still won't scan any HD channels on 82 settings, signal everything is on point. Any idea why it won't scan?

[jvvh5897]

Wrong settings? Bad cable? Bad LNB? Bad Switch? Dish not aimed right? Not using right scan? Bad module replacing bad module?
You are not really giving much info in your post--what dish, which LNBs, what settings....

[jas123]

The entire dish was reallinned yesterday with brand new cables.

[nobodyspecial]

Does 82 appear at top right in settings?
Post your set up and settings

[chad1976]

Do a fatory reset 3 time.Then off on the back and back on.That should help.

[nobodyspecial]

Can you also post what it says in system info?

[jvvh5897]

"cables"--plural--suggests a heavy LNB load and a known issue is a heavy load from provider equip causing switching issues so you don't really get a good switch action. Normally, the suggesting is to isolate the LNB for the satellite you have an issue with by hooking directly to it (if possible). Lots of posts in the section about it.

[jas123]

Setting and everything is on point. I'm getting full signal on my Jynxbox also tested DL200 on my friends box it worked like a charm not sure why it wont work on my T5 :( i did factory reset and all everything works on the box just wont scan any birds not even bird 91 which is SD. Any other suggestions to make this box fly again?

[jets]

What is the firmware on the box?

What type of LNB are you connected to and what are your switch settings? I have seen the T4 act up after a reset. Check you symbol rate an modulation on 82 after a reset to make sure it's TURBO.

[staticrider]

Will your box work at your friends location? While there clone his settings and retest.

[jvvh5897]

You could load a good channel list, set it up for your LNB/Dish needs and then see if it receives the channels.

[jas123]

Where can I can the channel list from?




You could load a good channel list, set it up for your LNB/Dish needs and then see if it receives the channels.

[nobodyspecial]

there hasnt been one posted
does it say 8psk in system info anywhere

[staticrider]

What dish are you using???

[jvvh5897]

Where can I can the channel list from?

Maybe from "my friends box" that you tested the module on, otherwise check the files section.

------------edit-------------------------
Don't see one on this site, but see an old one on a site found with google.

[jas123]

yea it does read 8psk on system info

[jas123]

yea it does read 8psk on system info.




there hasnt been one posted
does it say 8psk in system info anywhere

[nobodyspecial]

yea it does read 8psk on system info.
That shows the board is installed properly
So now you need to post your setup.lnb type ,switches if any ,how wires run and your complete settings