problems with setup

[harddrive4096]

Finally got the new DL t5 hd.
Loaded the new bin.
The sats I'm connected to on a legit subscription are 61.5 and 72

My 2 problems are cant connect to server but i think that is a fat finger from the ipk guy.
The other I cant get blue bars on 61, I have to be on nimiq 82 for the 61 to lock and it says echostar 61.5 with good signal and quality.
To get 72 to lock I have to be on echostar 110 and it locks to 72 echostar with good quality.
I can scan and get channels but the epg is hosed, I try to sort by E* and it gives a error.

any ideas how to fix this?

[nobodyspecial]

You sure your server supports those sats? Not many do

[harddrive4096]

no idea, new to the game

[harddrive4096]

Ok i've acquired an old dishpro dish with the dual lnb's built together. I have a connection on both sides for cabling, I assume it's for running to stb's.
The T5 has a 2.5 amp power supply so do I need to still run a power inserter? If so will a totally separate wire coming from the inserter go into the other open port? Right now the T5 will power both, just wondering since it's a pain in the ass to run the wires from atop the house.
Or can I make a short wire run the T5 into the inserter, the the output of the inserter go to the dishpro?

Thanks
HD

[nobodyspecial]

you only need the power inserter to run the dish 1000 series or a dishpro plus
Can you post all the info that it says in system info in your menu?

[harddrive4096]

I have a dp 500 with a twin legacy lnb.
What is the setting for this type lnb? Single, ocs-dp, sorry for so many dumb questions but I can't seem to find the setup

Thanks
HD

[nobodyspecial]

I have a dp 500 with a twin legacy lnb.
What is the setting for this type lnb? Single, ocs-dp, sorry for so many dumb questions but I can't seem to find the setup

Thanks
HD
try single for lnb type and use legacy sw sw42 dish 2 for 82,sw42 dish 1 for 91

[nobodyspecial]

thought you were going for 82/91 Just adjust for the sats you are aiming at