no signal after trying to get 110 channels back

[fairlaidy]

i been trying to get all channels back i delete all channels and did a auto scan with network on and it won't get no channels at all i can't even get signal on any of the sats any help will be appreciated I'm on a 1000.2 dish Thanks

[donster]

110 changed to 8psq and if you read some of the posts in you receiver section you will see what Ian happening. 110 in limbo for now.

[fairlaidy]

110 changed to 8psq and if you read some of the posts in you receiver section you will see what Ian happening. 110 in limbo for now.

yeah i have been reading and saw a few post about edit tp and other option to get the channels back even tho they are dark but i can't even get a good signal did i miss something else?thanks

[iq180]

yeah i have been reading and saw a few post about edit tp and other option to get the channels back even tho they are dark but i can't even get a good signal did i miss something else?thanks
Yes you did miss something, first you didn't need to delete the CHs, all you needed to do was edit the TPs and if you don't edit the TPs you will never get any CHs on sat 110.0w, next never use blind scan on a provider sat/ next, network search should be off,
and you should use auto scan.

[monchino]

check the jb200 module , after a factory and tp,s update if no signal on 110

[fairlaidy]

ok found out i had a switch problem got signal back.now i edit tp's on 110 and got channels back just want to make sure they are 29 tps on sat 110 right just want to make sure i didn't delete any of them thanks again

[teekster]

When you say "edit tp's on 110" does that mean edit all of the tp's to HD settings? For example,what is the correct setting for 12224 tp? Should I change all of them to this setting?

[Dan2015]

no it should be 12224/21500 go through all of them and make sure there same so the next one would be 12339/21500 all of them end in 21500 good luck

[Razorboy]

When you say "edit tp's on 110" does that mean edit all of the tp's to HD settings? For example,what is the correct setting for 12224 tp? Should I change all of them to this setting?

I have a sv8000hd and it is very simple fix on this unit. Its a pain in the ass but you must change all the tp that give you "no signal" from 20000 to 21500 and on my unit change to turbo8psk.

So the correct setting for 12224 is 12224/21500 and change to turbo8psk.and so on all to 21500 turbo8psk

[uppadharmai]

Is this only for 110w or must the tips also be changed on 119w and 129w

[iq180]

Is this only for 110w or must the tips also be changed on 119w and 129w
Sat 110.0w is the only 1 you need to edit for now.

[uppadharmai]

I changed the suggested tps on 110w but I am not getting signal on that, or 129w