Log in

View Full Version : Can' t connect to server


geevee
08-10-2015, 10:13 PM
Trying to set up my new T4.
Followed the set-up post and all files and channels loaded fine as per the posted instructions.
Except the PPV and Adults which must be a different issue.
I then tried to load in the server info which I had been using with my old Nano premium for the last 6mths.
I triple checked the info as I was loading it but is says "can't connect to server"
I then re-entered each line over and tried to connect after entering each one separately
but still can't connect. I thought this may find the error but I'm sure all the info was entered correctly
Just as a note that I am getting channels 101,102 and 349 which are all info only.
Everything else is scrambled.
Any help would be great.. thks
nobodyspecial
08-10-2015, 10:15 PM
Trying to set up my new T4.
Followed the set-up post and all files and channels loaded fine as per the posted instructions.
Except the PPV and Adults which must be a different issue.
I then tried to load in the server info which I had been using with my old Nano premium for the last 6mths.
I triple checked the info as I was loading it but is says "can't connect to server"
I then re-entered each line over and tried to connect after entering each one separately
but still can't connect. I thought this may find the error but I'm sure all the info was entered correctly
Just as a note that I am getting channels 101,102 and 349 which are all info only.
Everything else is scrambled.
Any help would be great.. thks

maybe contact your seller to check
geevee
08-10-2015, 10:24 PM
It must still be fine cause when I plug in my nano premium it still works with the few 119 channels that still work
snowman777
08-10-2015, 11:05 PM
Check the Dreamlink file section and look for the file Make2Dream, it will load the server in for u. I only saw one for the t5 not sure if it's the same and will work on the t4.

P.S. Found it in the DREAMLINK T4 SD FILES.
nobodyspecial
08-10-2015, 11:11 PM
Check the Dreamlink file section and look for the file Make2Dream, it will load the server in for u. I only saw one for the t5 not sure if it's the same and will work on the t4.

you need the make2dream for the t4
nobodyspecial
08-10-2015, 11:37 PM
its posted here
http://www.satfix.net/showthread.php?137530-Make2Dream-T4
geevee
08-10-2015, 11:52 PM
I may be in some trouble as I'm not that computer savey.
But I'm going to give it a try.
Is there any other easy way to load in the info?
Why will it not work with a direct input using the remote?