south 110 and 119

[rat123]

Hi
So if 110 and 119 are going to all HD and there will be no SD. Is there a new channel list
Thanks

[gAsH]

Hi
So if 110 and 119 are going to all HD and there will be no SD. Is there a new channel list
Thanks

'You are just a bit confused and understandably so as there are a lot of changes going on. I'll try to make it easier to understand.. So as of now Sat 110w has changed their transponders from mpeg2 to mpeg4 aka QPSK to T8PSK. This means (in easy terms) that you require the same module to receive channels on the new mpeg4 transponders as you would to receive HD channels. This makes most SD receivers obsolete for 110, (and soon to be 119), 129 sats as they are not 8psk compatible.

The channels are not being changed over to HD but rather to the same 'format' that HD channels use to broadcast through the satellite signals. By making these changes they can carry a lot more channels and information on a single transponder. But they will not be in HD quality as it is only the format in which it is delivered that is changing. This means you will require the same hardware to get reception on SD channels as you would to get HD channels, regardless of the quality (HD/SD).

Anyways, I hope this helps you to understand what these changes are all about. Good Luck :thumbsup:

[rat123]

Hi
So will my dreamlink with a red HD chip work. I noticed all my lower channels in 110 do not work anymore
If not what receiver will work
thanks

[gAsH]

Hi
So will my dreamlink with a red HD chip work. I noticed all my lower channels in 110 do not work anymore
If not what receiver will work
thanks

It is not just you my friend, several services are missing a bunch of the lower channels and some 200's. Just be patient and it will come back. As long as you have a signal on all the channels then your settings are all correct. :yes:

[rat123]

Hi
I had no or bad signal on some channels. So I did a factory reset and now I'm getting good signal but only scrambled channel
So now I have to be patient
thanks

[KIDWCKED]

So I had to do a hardware upgrade to T8PSK and I have the channels back now. But for some reason I can't get the EPG to populate. It just says "no information". Any ideas on how to fix that? Thanks in advance.

U hijacked this thread...better off starting your own in the reciever forum..

[rat123]

Hi
what channels are working on 119
thanks

[Grizz]

Hi
what channels are working on 119
thanks

None here.