Programing the Remote control

[abouttosnap]

Programing the RCU

Automatic Code Search:

I. Usnig Automatic Code Search
1) Turn on the component you want to control (TV, VCR or DVD).
2) Press and hold the component key you want to program. Holding the component key until the LED on the
remote control turns on, then release the key.
3) Point the remote at the component, press and release the UP (▲) button, then wait three seconds or
until the LED stops flashing.
At this point the remote control is searching for the correct code to program. If, after three seconds, the
component you want to control does not turn off, press and release UP (▲) button again to tell the
remote to search the next set of codes.
4) If the component you want to control does turn off; Press and release OK Button , then the LED blinks
three times.

[abouttosnap]

II. Using Direct Entry Method
1) Turn on the component you want to control (TV, VCR or DVD).
2) Locate a Code List. Find your brand of the component you want to control.
3) Press and hold the component key you want to program. Holding the component key until the LED on the
remote control turns on, then release the key.
4) Enter 3-digit code from the code list, then the LED blinks three times.
5) If you get no response, repeat these steps using the next code listed for your brand until the component
responds to the remote control command.

**Note...maybe best to google to find the newest code for your component...found a three digit code for my LCD tv but it doesn't completely work all the options...such as the input source which I need when going from OTA to stb.**