Jynxbox Ultra Lite.....Dead???

[CatsRme]

I loaded a file onto my jynxbox lite abit ago and now will boot to green light but screen says no signal
I tried using red yellow and white video cord as well was hdmi.....
I look and searched on line but dont see any ideas....
Any one have suggestions?

[Nostradamus]

try setting your sats to the right ports?

[CatsRme]

I cant even get it to boot into bootup screen ...let along initial screen to get to the menu

[steven charles]

fr
I cant even get it to boot into bootup screen ...let along initial screen to get to the menufriend try loading the factory file with the pin cables that came with your receiver,keep force loading it,it,ll take the download sooner or later....

[CatsRme]

I used the had loader and the jynxbox lite 035 file.....is this correct?

[steven charles]

I used the had loader and the jynxbox lite 035 file.....is this correct?friend if you go to the jynx ultra lite files its the the one on the bottom of file v031 bin it says factory file on it,try loading that one....

[CatsRme]

I get a whole slew of packet errors....continue or quit and retry

[Hunter11]

I found this not sure if it will work on your unit or not so don't shoot the messanger, Once you have exhausted all other avenues this may be an option for you. Good luck.C/P

Credit to Sp0iler:

How Force load the factory (or any other) bin file....

Load the factory bin to your usb stick.
Insert the stick and shut the box off from the rear switch.
While holding the "Menu" button in on the box, restart from the rear switch.Hold the "Menu" button for at least 5 seconds when you boot from the rear.
This will put the box in USB mode and you can use the buttons on the box to navigate and force load the file.
Restart as normal and load the current file for your box .


Good luck,
Sp0iler

[CatsRme]

Keep the ideas coming ...cause nothing worked yet......and Hunter ...I have jynxbox lite box...don't have menu button on the Box itself

[Hunter11]

People used to force load the old nfusions by using the rs232 cable and the loader tool.

once you have the loader ready with the factory file then turn the reciever on and then start the loader a second or two after. May take several tries but many had success with the nfusions by doing this. You may have to read the link below and possibly incorporate some of the bootloop technique for it to work. Let us know if you find a solution.


http://www.satfix.net/showthread.php?124736-How-To-Fix-Bootloop-Problem

[Hunter11]

Could this possibly be as simple as pressing the stb button on your remote to regain control of the unit, or try new batteries.Just sayin you would not be the first. The reciever is giving you a "no signal" on the screen.
I loaded a file onto my jynxbox lite abit ago and now will boot to green light but screen says no signal
I tried using red yellow and white video cord as well was hdmi.....
I look and searched on line but dont see any ideas....
Any one have suggestions?

[CatsRme]

Could this possibly be as simple as pressing the stb button on your remote to regain control of the unit, or try new batteries.Just sayin you would not be the first. The reciever is giving you a "no signal" on the screen.



What stb on the remote......I did try the aspect button