DiSEq with power inserter

[TurboPirate]

Hello gang, for 4 SATs and 3 receivers I need a DiSEqswitch with ppower inserter, all 4 SATs are linear FTA every time one receiver goes to No Signal the only way that works is if both or 3 receivers are on same channel, what DiSEq switch with power inserter are easy to find? Thanks in advance TP

[steveOtoo]

You would probably get a better response if you listed your setup,dishes,lnb's,switches etc. Diseq switches are easy to burnup, always pull the plugs on all recievers when working on this type sw. when removing coax.

[TurboPirate]

SATs are 30w, 125, 40.5 and 116.8 all have 3x4 switch on each LNB, from there 3 DiSEq switch 1 for each receiver. TP

[steveOtoo]

Here is a very comprehensive switch guide

[Terryl]

Not a bad guide, but Dish engineering (EchoStar) has modded some of the DPP switches to make it harder to use on non dish equipment, (modded to be used with the hopper/joey systems) Dish does not give a darn about other types of receivers, they make it work with their equipment and don't care about others

So that guide may be a bit out of date as some combinations may or may not work, so experimentation is the only choice, or you could go with a good EMP switch.

[TurboPirate]

Hello Teryl, happy new year, yes I can go with emp but don't know wish one is more suitable for this setup....

[Terryl]

If you go to their website they have app guides.

[TurboPirate]

OK I'll check again but I got confused reading the info of installation all models with power supply mention using quad LNBs not dual LNBs.