Missing 345 & 346

[dogdayz]

All of my DN channels are working ok but I have two receivers that don't get 345 & 346. They used to work but it would be intermittent sometimes and now they don't come in at all. Signal strength seems to be ok.

Anybody have an explanation?

I am using Dreamlinks on satlobo.

[dishuser]

All of my DN channels are working ok but I have two receivers that don't get 345 & 346. They used to work but it would be intermittent sometimes and now they don't come in at all. Signal strength seems to be ok.

Anybody have an explanation?

I am using Dreamlinks on satlobo.not being subbed

[dogdayz]

So you're saying that nobody gets them, it's not a problem on my end?

[torpainter]

345 tp 12326 sat 110
346 tp 12443 sat 110
If your info is the same as this its your server that is not supporting it

[c8rbk1ng]

Satlobo has those channels and they are up...something wrong on your end.

[dogdayz]

Hmm! My receivers show the correct transponders. I don't know what else to check.


345 tp 12326 sat 110
346 tp 12443 sat 110
If your info is the same as this its your server that is not supporting it

[torpainter]

A rescan would not hurt.

[dogdayz]

Well, I see why the channels aren't working but I don't know the solution.

I rescanned the 110 bird and those two channels didn't come back into the guide. So I went to do a manual scan for just those two transponders and it shows no signal Q.

It seems that I am not getting anything on the horizontal polarized transponders for 110. Does this sound like I need a new LNB on that dish?


A rescan would not hurt.

[torpainter]

Which model?
Post your hardware and settings

[dogdayz]

I have a Dreamlink T4 and a T5 - same problem on both. The LNB is a dual output legacy.

I have separate dishes for 91, 110, 119 connected via 4x1 diseqc switches.

Since I have two receivers experiencing the same problem, it appears the only common element is the LNB. If it was summer I could scramble up to the roof and change it but it's dangerously icy up there now. :no:

[torpainter]

I have a Dreamlink T4 and a T5 - same problem on both. The LNB is a dual output legacy.

I have separate dishes for 91, 110, 119 connected via 4x1 diseqc switches.

Since I have two receivers experiencing the same problem, it appears the only common element is the LNB. If it was summer I could scramble up to the roof and change it but it's dangerously icy up there now. :no:

lnb type set to single? Before i replace the lnb I would run 110 directly to rcvr and check it out

[dogdayz]

Yes, it's set to single. I can reach my switch with a ladder so I'll try connecting 110 directly - awful cold out now so it may have to wait. I'll update when I give it a try.

Thanks for your help.


lnb type set to single? Before i replace the lnb I would run 110 directly to rcvr and check it out

[dogdayz]

Well, not so cold today so I tried running 110 direct to the receiver. Nothing changes, no H transponders.
So, I guess it must be a bad LNB and I can't change that until the ice is off my roof.


lnb type set to single? Before i replace the lnb I would run 110 directly to rcvr and check it out