Why No signal when changing Sats

[Cric]

HI ,
This may have been asked before pardon me!

As you know issue is when go from 118 or 119 ch to 110 ch its fine but when I go back to 118 or 119 ch receiver says no signal. Then i have to reboot box and its ok.
Whats issue anyone know, i know kbox had exactly same issue.

I have two dish, 110+ 118,119, 4x1switch, one box. Dish is grounded properly.

Thanks for info.

[KIDWCKED]

try a different switch...emp not a good choice...i put on an old generic cnx switch..and that issue was solved..most say baff switch for these boxes rule..

[Cric]

Thanks Kid,, i will give it try for sure,

[pgjeepster]

Yup I had EMP switches on my setup and was always re-booting because no sig or bad I went with a chieta and no issues since, strange how one swap will make a big difference