Nano HD 129 download problem

[Bill]

1000.2 Dish
LNB Freg DishPro LNB{11250
DisEqC Port3
Signal 87
129 Locked
Transponder {33/42 124545 v 21500
I am getting a lot of Failed. It will start to load go to 15 to 30% and start over? My 110 and 119 downloaded fine.

[Terryl]

Maybe not enough go juice to the LNB maybe?

You have enough DC power?

[Bill]

I have another dish receiver connected to the dish. Thanks for the reply Terryl.

[Bill]

I am running a Nano HD receiver connected to a dish 1000.2 in Nevada. I am having problems downloading the 129 Sat. Could someone that has a Nano HD setup on a 1000.2 dish post there setting for the 129 Sat?

[bkr™]

I am running a Nano HD receiver connected to a dish 1000.2 in Nevada. I am having problems downloading the 129 Sat. Could someone that has a Nano HD setup on a 1000.2 dish post there setting for the 129 Sat?
The settings are standard receiver to receiver, ocs dp, diseqc port 3, however on older receivers sometimes you need to change the tps as the menu does not have the correct ones. Go to
www.lyngsat.com/129w and check your list as compared to lyngsat.

[Bill]

The Nano HD does not give a OCS DP option.

[Costactc]

The Nano HD does not give a OCS DP option.

Dishpro lnb(11250) in antenna settings.

[Bill]

That's the setting I have tried to use and I am getting only part of the HD channels and after the download I am getting no signal.

[Costactc]

I sometimes have no signal issues as well. All I do is go into an advanced tp scan and go through the tp till I get a lock-this also happens to my dl hd as well. Think I'll be changing switches once this frickin snow goes away. Have you tried removing and inserting your module, which may be the problem.

[bkr™]

There are not all tps you will receive after scan but they are near the end of the list on lyngsat that you should get.