cheapcat
03-14-2014, 05:28 AM
Just got my new T5 today. Set it up according to the setup instruction on here. After doing a scan, I realized that I am only getting the channels on the horizontal transponders, none on the vertical ones. Here is my setup:
1000.2 dish with power inserter.
LNB power on
LNB Type: OCS-DP
LNB Frequency: 11.250
LNB 22kHz off
DiSEqC SW1.0: 119-1, 110-2, 129-3
DiSEqC SW 1.1: off
Legacy SW: Off
For the horiz transponders, the S and Qs are all green and around 80%. For the vertical transponders, S and Q are all red, but over 95%.
Used a voltmeter to check the voltage output from the receiver. 18V of H transp. ad 13 for V. So the receiver is good. What else could it be? Any suggestions? Please help! Thanks in advance!
1000.2 dish with power inserter.
LNB power on
LNB Type: OCS-DP
LNB Frequency: 11.250
LNB 22kHz off
DiSEqC SW1.0: 119-1, 110-2, 129-3
DiSEqC SW 1.1: off
Legacy SW: Off
For the horiz transponders, the S and Qs are all green and around 80%. For the vertical transponders, S and Q are all red, but over 95%.
Used a voltmeter to check the voltage output from the receiver. 18V of H transp. ad 13 for V. So the receiver is good. What else could it be? Any suggestions? Please help! Thanks in advance!