Hello

[Welshman]

Hello Everyone! I am new here, but have been playing with FTA since 2007! I have been out since the card share started. After doing a lot of reading it seems to me that if I want to use my nfusion solaris, I should start by using Noi as it is the easiest to use to set up card share! It is not a virgin box. so would I need to start from scratch? Do a factory default and then load all the files foe Noi into it, or could I just add the ones that aren't loaded into it? I have all the files for it, I am just asking! I know that no question is a stupid question, only the ones not asked! I would rather do it right the first time, rathewr than just do what I think and then have to come back here and ask for help on how toi clean up the mess! Thanks! If there is a better program, I am all ears! Thank You once again!

[Akili]

Hi and Welcome to satFIX
http://t1.ftcdn.net/jpg/00/45/65/98/400_F_45659811_yKRTO3mmuYHyQ2amUI8qSAvDM6NS9wJy.jp g

[belvedere]

welcome to satfix welshman

[homedoc1944]

Glad to see you here at Satfix Welshman.

[Welshman]

Thank You for the Welcomes! I am glad to be here! I was wondering if any one had any answers to my questions? Kinda stuck and was wondering!
Thanks again!

[Newfygarge]

Welcome
I'm pretty sure these are the steps to get NOI working

Nfusion Nova/Solaris/Phoenix using NOi


--------------------------------------------------------------------------------
If Your Nfusion was ever been converted you need to convert back to original.....
good luck and happy testing(skip step 1 if your reciever has never been converted)
(If your reciever has never been converted skip step 1)

1. Load the boot_g3x_to r3x_v1.23.bin file in BOOT mode.
Load only if European conversion like T54/T58 has been loaded.

2. Load this file u48 factory file from July 2009 also in MAIN mode.

3. Load this file next... boot file v.130 also in BOOT mode.

4. Lastly load this file 090928 sol phoenix sd v153 1 (Maintenance release) in MAIN mode.

5. Then load newest file which is nfusion-154.2-255.bin in MAIN mode.

6. Setup LNBs

7. Scan Channels

8. Go to channel 200 and turn off receiver

6. Start NOI

7. Go to Settings and enter your PS Info.
IP Address:
DN Port:
Username:
Password:
Be sure to use colons in the key like this
99:99:99:99:99:99:99:99:99:99:99:99:99:99
and hit save.

8. Go to Main and hit Start. If you see snow your all set. If you get a connection error try using the server IP instead.

9. Turn on receiver and watch TV.

[Welshman]

Thank You Newfygargle! I was stuck there, and did not want to do something that might cause me grief down the road! Thanks again! Do You have any opinions on a different program for nfusion, such as Goo3?