alittle help please

[rockhard]

can anyone tell me if the linkbox local will run off a multi switch or just the disque switch , as i have no sat signal with my multi switch , my other boxes are using the multi just fine , thanks

[rockhard]

i got the linkbox local , i opened the box and loaded the bin 137 via usb ,did flashburn , went to sats ans hot a lick of signl 119/110 , everythings ok with my other boxes , usuing a multi switch , any ideas would be a big help , or do i need to load any other files besudes the bin 137 ,

[dishuser]

you only need one thread

[Anubis]

you only need one thread

Merged them. :thumbsup:

[rockhard]

this thread can be closed , got it up and running

[omijam]

what was the problem. I have one with no signal
first test it as new in the box, i got signal but no channels
then install the module that came in a little box
factory
new bin
antenna setup
scann

...fail
...fail
no signal

[omijam]

just verify if M1 was burn but it doesnt look burn

power off box for a couple of minutes, there is signal, in less than 5 minutes, no signal

can this box power a DP34?

119, port2
110, port1
DP34
linkbox 8000 HD Local

[omijam]

just discover that with dv module the box works ok. but with the LS500 module the linkbox 8000 HD lose the signal on all transponders. can not scan because the is no signal
but if the original module is installed, the box works ok again.
any help please?

[nelsonsylvester47]

the module might be bad