Limesat ultra v1 question

[lroy]

Which p$ file is for the limesat ultra v1. Is it the 174 or the 175. After loading the 175 on my limesat ultra v1, l am unable to get it to do a factory default. InsteadI get a error message on the display and please wait on tv.
It will not even allow one to load any factory file either by usb or null cable. Any ideas.....

[marcel.crash]

the 175 is for the v1 if you can get to the system information it will show there what version you have

[Recove52]

Whooooot... load the 2.73 for the version 1 LS ultra , turn japan poblic to off load your server info on page 1..as far as what version remove the cover look in lower right hand bottom corner you will see V-1 or V-2 along with date of assembly use 2.75 for the version 2

if you cannot load via usb load factory 2.01 first via usb if it will not load via usb use the loader and follow these steps once you have the file loaded then load the 2.73 via usb...then setup your sats and scan ,then enter your network and sderver info save each line as you enter with the green button ,once all has been entered an saved initiate the server with the blue button, when you see caid connect , exit out to a working ch.

here are the loader instructions , follow exactly
C/Pfrom WebWizard...................1. Start the loader and set the com port.
2) Select file to you want to load.
3) While holding in the front panel power button reboot box and hold power
button on box in for at least 5 seconds while rebooting.
4) boot should freeze in display.
5) Press start on loader and file should begin transfer. When countdown is less
than 4 digits numbers are prefixed by letter A will appear.
6) When the display hits zero it should change to -E5-.
7) WAIT !!!! The Display on loader should be at 90% at this point.
8) The receiver should then start counting down prefixed with a "P". I assume
that is for 'PROGRAMMING'.
9) When the receiver displays -End- wait a few seconds, look at loader program
which should now be complete, and then reboot box.

[Anubis]

There is no need to load any other file other than 273 on the unit. The 274 and 275 files were released to update the flash as the 2012 models (v2) had a different flash installed.

[Recove52]

2.74 was released to fix a connection issue, an your saying this is because of a different flash in V-2

[Anubis]

2.74 was released to fix a connection issue, an your saying this is because of a different flash in V-2
No, it was released because the new receivers had a different flash and it upgraded the flash. That was reason for it. It had nothing to do with connection issues.
You might want to go to the files section and check again but you will see I am right. ;)