2 nfusion on the same noi

[dan_boo]

Hi,

I m looking for buy a second nfusion. I just want i know , how to do the setup on the noi for the second receiver.

Thanks

Dan_boo

[AeonFlux]

Connect both receivers. When you have them set up, turn them off.

In NOI go to the advanced settings tab
there will be 4 servers for South and 4 servers for North providers

Assuming you test the South Provider...
Fill in 1st South server data for your 1st South receiver
Fill in 2nd South server data for your 2nd South receiver

If you test North provider just do North server data instead.

Ok now check the box that says USE THESE SETTINGs

goto main page and click START. NOI will not connect to a server until you turn one receiver on.

Turn on the 1st receiver and select a channel such as 200.
NOI will connect to server 1 and begin to service the 1st receiver.

Now tun on 2nd receiver.
NOI will connect to server 2 and begin to service the 2nd receiver.

NOI assigns server in order the receiver is started up. If you change the order you start them they will swap servers.

[dan_boo]

Great!!!!

Thanks a lot

Dan_boo

[walter]

Followed the above instructions but the two stb's are fighting for the same server slot within NOI. Any suggestions?

[riverman]

The only reason 2 receivers would fight is if you have only one code. Do you have 2 different codes?

[walter]

The only reason 2 receivers would fight is if you have only one code. Do you have 2 different codes?

Yes two different codes entered in server 2 and server 3 spots.

[ricky1lung]

i think i read somewhere that for noi to work 2 receivers they need to be an hd and an sd not 2 of the same the goo3 method with a router works great thats what i use and i think iks4suns can run multipals but you have to run its mock router program with it its in the folder check here

http://www.satfix.net/showthread.php?137948-IKS4SUNS-Ver-2-00-Single-Multi-Server&highlight=iks4suns+2.0

and here

http://www.satfix.net/showthread.php?136827-Goo3-dd-wr-goo3-v24_micro_generic&p=972053#post972053

[virgilio]

nfhd have conflict when you have more than one reciver, use router linksys with goo3

[riverman]

are you sure the problems you are having are related to 2 codes in NO1 and not signal problems relating to 2 receivers sharing the same sat. dishes

[walter]

Ok thanks guys. Looks like this is the push I've needed to get going with Goo3.