118.8 bird or channel editor

[nutty]

I have 5.02 bin and I do not have transponder for 118.8 bird. I have 119 and they are connected to the same lnb. I read more and there was information to modify 121 bird but it does not get locked at all and I cannot add transponders manually to do a scan.

Any help is good. Also any channel editors that can be used here?

Thanks,

[dreamingsky]

visit lyngsat.com and get all TPs..one by one add tps and frequency in bird 119, scan manually, you will get all missing channels. otherwise glitches in Nf drive you mad. hope it works for you.

[steven charles]

I have 5.02 bin and I do not have transponder for 118.8 bird. I have 119 and they are connected to the same lnb. I read more and there was information to modify 121 bird but it does not get locked at all and I cannot add transponders manually to do a scan.

Any help is good. Also any channel editors that can be used here?

Thanks,friend are you using the special circular lnb for sats 118-119,and what size of dish are you using for sats 118-119,because you need at least a 30 inch dish for sat 118,good luck friend...

[nutty]

You are right. i have 30 inch dish. the problem is this that I do not have 118.8 in my antenna settings and i cannot scan it. How to do it?

[Jdread]

The settings in the receiver for 119W & 118W must be 10750 and not 11250. Make sure that if you are using a switch the port must be the same for both 119W & 118W. If you are using 121W make sure all the Transponders are set manually to reflect those on 118W, go to lyngsat. The receiver is going to tell you that the Satellite is unknown when you pick it up but you should be able to scan and get the channels, you will have to Edit the channels to put in the proper name. There will be no EPG.

[steven charles]

The settings in the receiver for 119W & 118W must be 10750 and not 11250. Make sure that if you are using a switch the port must be the same for both 119W & 118W. If you are using 121W make sure all the Transponders are set manually to reflect those on 118W, go to lyngsat. The receiver is going to tell you that the Satellite is unknown when you pick it up but you should be able to scan and get the channels, you will have to Edit the channels to put in the proper name. There will be no EPG.friend try doing a factory default and then re-enter the settings again for the sat and then try reloading the factory file again for that receiver and then it should appear on the lineup,good luck friend....