PDA

View Full Version : Jynxbox connection problem?


gwrowe
04-09-2013, 03:55 PM
Anyone else have connection problems with this unit? Every time a ch. freezes, the receiver disconnects from the server, in order to get it to connect again, I have to go to PS info area and apply a couple of times and it keeps saying connection failed, once I exit out, it will connect to server, after quite a few seconds, sometimes I have had to do this a couple of times before it would reconnect, anyone know how to fix this problem?
iq180
04-09-2013, 06:18 PM
Anyone else have connection problems with this unit? Every time a ch. freezes, the receiver disconnects from the server, in order to get it to connect again, I have to go to PS info area and apply a couple of times and it keeps saying connection failed, once I exit out, it will connect to server, after quite a few seconds, sometimes I have had to do this a couple of times before it would reconnect, anyone know how to fix this problem?
its your PS, when it does that try CH up then back Down.
gwrowe
04-09-2013, 10:13 PM
Tried that, doesn't work!
Dynas
04-09-2013, 10:16 PM
What file are you running?
iq180
04-09-2013, 10:22 PM
turn off the jynx and reset your internet.
tito2020
04-09-2013, 10:23 PM
Sounds like a ps problem.
gwrowe
04-10-2013, 01:42 AM
Running file 233, and the Internet is working fine!
Anubis
04-10-2013, 11:34 AM
Double check your info to make sure that there is no space at the beginning and make sure to turn the server on in server menu before trying to connect.
iq180
04-10-2013, 12:24 PM
look at your server port, I have seen reports that for some reason it will change on its own, if it has then you need to report it
to your PS, and get a new #.
Dynas
04-10-2013, 01:10 PM
After I loaded the 239 file most of my problems cleared up.
tonyboy1223
04-12-2013, 11:55 AM
I Have some time this problems.
If channel freeze, or no signals, i have to change Channel Up then Down or Down then Up, and working again...
Is it a receiver problems, version software problems ???
Thanks.
dishuser
04-13-2013, 02:47 AM
I cannot connect on either port since yesterday with Ultimate IKS running version 236. Anybody else having this issue?

you should ask in their thread
gwrowe
04-16-2013, 04:26 AM
Got the problem corrected, it was the code changing ports, on it's own, thank'e for your replies guy's!
venkat270
09-08-2013, 06:54 PM
Hi how did you fix this auto code changing?