Log in

View Full Version : reviving a cnx nano2 ilink conversion


gyu84
03-30-2013, 01:06 PM
I will assume that an ecm has knocked my receiver , the reason Im saying this is this has happened with my (cnx nano2 converted to ilink)
about 9:30-10:00 last night. completely gone no guide but if you turn off and watch closely when turning back on it will flash guide for a second.
My tv will shut down if it doesnt have a signal , it is not receiving the signal from receiver, does this mean the tuner is out?
StanW
03-30-2013, 02:06 PM
Can you access any of the menus?
gyu84
03-30-2013, 06:53 PM
no, nothing comes up, completely gone no guide but if you turn off and watch closely when turning back on it will flash guide for a second.
StanW
03-30-2013, 07:08 PM
Power off the receiver , disconnect everything except video to tv. Anything come up ?
gyu84
03-30-2013, 07:18 PM
same results, one thing I notice , unscrewing coax I got a slight tingling shock, touched a few times on the grounding( not the copper pin in middle) with this tingling shock.

watching closely when turning back on it will flash guide for a second
StanW
03-30-2013, 07:40 PM
same results, one thing I notice , unscrewing coax I got a slight tingling shock, touched a few times on the grounding( not the copper pin in middle) with this tingling shock.

watching closely when turning back on it will flash guide for a second

That doesn't sound too promising .lol Did you inspect the power board ? Leave it unplugged for a few hours .
gyu84
03-30-2013, 07:42 PM
Im unplugging and will inspect tomorrow, Ill post back, Thanks you have a Happy Easter, keep the lord in your heart.
catthepatch
03-31-2013, 12:54 AM
Best check line and switches for shorts. Sounds like a short.
StanW
03-31-2013, 01:27 AM
Best check line and switches for shorts. Sounds like a short.
Didn't we do that in post 4 above ? ;)
gyu84
04-12-2013, 12:20 PM
update : its down no results, time to shop for replacement.
clarkie
04-12-2013, 12:25 PM
Load the factory file on it.. if it wont power on , do a force flash..meaning u connect to loader to it at the computer and try hitting connect on the loader at the same time as you power on the box...it will work it might take a bit but it will work

i would all so check your LNB they may be blown