Something's wrong... Not too sure what....

[Irowdy]

Hi all,
Made the mistake of doing a factory default reset. thought that would help me with the freezing. Now, i can't seem to connect to server 1. This is what i've verified:

1. My code is valid;
2. Its been entered properly (checked and rechecked);
3. I'm connected to the internet (my ip setup is showing that i'm connected);
4. Auto tp is set to on;
5. I've inputed IP address in the server section of net application and made sure that my "input type" is Ip address;
6. Au is off ( always was in the past);
7. Ch 101 is working.

I dont think its my modem or router because all other devices connected to them are fully functional. Should i,regardless, shut down my modem, router and receiver and reboot e everything (worried to tamper with my modem and router)?

Any help / advice would be greatly appreciated!

[Glatt]

When you do a factory reset the network goes to dream. You have to reset it to work!

[hutch]

When you do a factory reset the network goes to dream. You have to reset it to work!

close ... lol... net application defaults to nano steam... you need to reset it to dream but if you have checked your code then you have already done that... which PS do you use? & what IP address are you using? Are you using the correct port for your code?

[Irowdy]

Nfps, ip 37.46.112.225 port is 17110

[Irowdy]

I finally rebooted the modem, router and receiver. Now i get the " connected: 1" but with no picture or sound. Still says scrambled.

[abouttosnap]

Not sure it would help but you could try fn1 and reboot the stb.

[Irowdy]

Back to square 1. :( i no longer see connected 1.

[djrm54]

leave it sit on for a bit and see if it finally pops in

[hutch]

try changing last 3 digits of your IP to 230 & reboot

[Irowdy]

Thanks for the recommendation guys but i think i might just pop in the recovery loader and start from scratch

[Irowdy]

And just like that, all is good!