ip setup problem

[jerruchne]

when i set up network setting on auto in ip setup and press apply nothing happen
only user dns numbers are on. I know the cable,adapter,rotor are fine because i tryed second nano 2 and that box
did ip setup fine.Any suggestions
Thanks

[Anubis]

Turn box off then reset your modem and router by unplugging them for 2 mins. Then plug modem back in and let reset then plug router back in and reset then turn box on.

[jerruchne]

thanx for quick respond i just follow your advice and stiil when i press apply nothing happen
this is used box i just get it ,everything else like scan sats,net aplication works

[jerruchne]

still can not get ip is it possible something wrong with my nano2?

[Anubis]

Check your dongle and make sure it's working.

[jerruchne]

dongle is fine works good with other nano2

[Anubis]

The only other thing I can think of is to factory default and set everything back up. Other than that it sounds like there's a issue with your signal from your dongle to the board which could be the actual input.

[party hard]

My Nano 2 converted does the same. I have to reboot and unplug modem several times before it picks up the info. I also go to the emulator and turn that off. The box turns that setting on sometimes on its own. I don't know if this has anything to do with auto apply for internet but you never know.

[gwrowe]

Did You Check to see, if there was a pin broken, in s232 port where adapter connects.

[jerruchne]

all pins in s232 are good,i did hard reboot,unplog modem,rotor and still can not get all ip setup when press apply
the only thig what shows is user dns

[gwrowe]

Is it set to auto!

[jerruchne]

yes it is set to auto

[gwrowe]

Then I would say, there is something wrong with the rec.