LNB & TP settings not saving

[kookaburra10]

Apologies for same post in iLink forum but no response there (my fault). Anyway, I can't get my LNB & TP settings to save. LNB zeroes out, TP just picks something seemingly at random (perhaps last channel??). I have to reset these settings each channel change. I've not had this problem before. I've deleted sats, re-scanned (119 first, then 110), hard booted everything. I'm hardwired into a 4G cell modem on a nano2/ilink box. Not sure what other info I can provide but any help/ideas would be greatly appreciated.

[gwrowe]

I have never heard of an LNB zeroing out before, post your antenna settings, as far as the TP changes, the TP will change due to last ch. Any way post your settings for both sat's.

[kookaburra10]

Thanks - I finally understand the TP changes; LNB for both 110/119 are 11250. I'm fairly certain they should not be?

[gwrowe]

Yes the lnb freq. is 11250 for both 110/119. Post your antenna settings, they should read something like this:


sat : echo 7 119w
diseq 1.0 port A
diseq 1.1 NONE
LNB Freq 11250
TP 12224 ( default TP)
22 khz off
Legacy off
Sat Scan All Ch.

Sat 110 should all be the same except the port should be set port B