S10 on Beaver North

[hammond]

I've searched and read and searched and read.

I followed the "how to set up an openbox" to the t.

It's not working. CCcam says "No Active" next to my connections.

I'm not sure if I even have good f/w because Nimiq 1&4 are not even listed in the satellite list.

The s10 is plugged into a standard bev dish with standard bev lnb (installed about 6 months ago by bev).

I need help.

[riverman]

some questions for you.
you have your receiver hardwired to your router with a known good working ethernet cable?
You have entered the 5 parts of information provided to you by Beavertv correctly?
You have the correct Lnb setting in your receiver and it shows you have a signal? Bell used Legacy lnbs before but now are installing DishPro. Makes a big difference which one you have.
Have you scanned for channels and downloaded some 500 channels?

[riverman]

Some info you should know before you waste much more time on your Openbox. Bell are in the middle of swapping out their subscribers receivers with machines that will process MPeg4. As soon as that swap is completed they will be broadcasting only Mpeg4 and your Openbox will be useless for Bell. You would be better off spending your time and effort on a new Hd receiver like the DreamlinkHD that will be working still after the swap is complete.

[nava]

Here is some help with open box .
First use a new firmware recently released which is "HDS2_Openbox_by_anonymouSX_V2_New_Red_GUI"
Then go in to your server set up go under CCCAM and then choose Add new
choose the first column NEWcam and enter all the details from your hobby provider
Once you enter save and exit then choose active which would be a green button on your remote and you will see a check mark
now exit and do hard reboot.

Also since this file is only for europe you do a factory reset and add your satelite that you wanted manualy then do a blind scan this box is pretty good with blind scan but little slow, faster than JYNX box.

Now you should be able to watch tv

i have some channel list but don't have beaver cause don't use them