dreamlink sd hdmi missing sats in list

[doggy10]

intalling a new dreamlink sd w/ hdmi and loaded factory file and 207 (didnt see that 208) was released. anyways after loading the files i went to set up the satellites, it did not have 110 and 119 in the satellite list. has anyone had this issue before? if so how do you go about getting the list of satellites updated to include 110/119 so the receiver can be set up?

[doggy10]

installed file 208 and still have the same issue. I have never seen this problem before and am not sure what to do. The closest bird to 119 is 118.8 for internationals. Any ideas? I did a factory reset and loaded factory file again and still nothing.

[KIDWCKED]

installed file 208 and still have the same issue. I have never seen this problem before and am not sure what to do. The closest bird to 119 is 118.8 for internationals. Any ideas? I did a factory reset and loaded factory file again and still nothing.

Try a reset after files are loaded...Just a thought..

[arflaw]

You must reboot with rear power switch after a file load.

[doggy10]

Well I'm back in at it again trying to figure out thus fn receiver. I loaded factory file again and did a reset then loaded file 211 and ones before that and reset and still having issues with the satellite list. It's still missing 110 and 119. So basically this stb is useless to me unless I can figure this out. When I choose 118.7 on the sat list and mess with the frequency settings it will lock on 119 as it appears on the top right. I tried to scan that and only get 120 channels. Does anyone have any ideas as to how to fix this problem? Thx

[KIDWCKED]

Did you follow this instruction doggy10??
dreamlink SD setup (http://phoenix.satfix.net/showthread.php?119112-dreamlink-SD-setup)

[bebe55]

HI Doggy10 I believe I'm the same boat with you . I got new dreamlink but can't find echostar sat too . do you fix the problem yet?. help me too . thank you



intalling a new dreamlink sd w/ hdmi and loaded factory file and 207 (didnt see that 208) was released. anyways after loading the files i went to set up the satellites, it did not have 110 and 119 in the satellite list. has anyone had this issue before? if so how do you go about getting the list of satellites updated to include 110/119 so the receiver can be set up?

[dishuser]

HI Doggy10 I believe I'm the same boat with you . I got new dreamlink but can't find echostar sat too . do you fix the problem yet?. help me too . thank you

did you load new bin and do a factory default?